redicting the physical and mechanical properties of rock today are an important role in optimizing mining operations. These predictions during drilling could lead to better results in mining operations such as blasting and crushing. This classification is affected by the parameters that can be obtained from the drilling machine during the drilling operation. A good estimation of drilling results can be obtained by measuring the rock properties and quantifying them. A rotary drilling machine used to determine some parameters during drilling. Texture and hardness tests have also used to measure rock properties. The samples selected on the basis of softness and hardness at the time of drilling and similar samples prepared for texture and hardness tests during preparation. For texture analysis, the sections were selected by microscopy and the texture properties of the specimens were determined. As well as Two Vickers hardness tests and Schmidt hammer numbers used to perform the hardness tests. The results showed a significant relationship between hardness and rock texture. In the last step, the vibration of the drilling machine measured in three directions. Vibration, texture, and rock hardness investigated after vibration analysis and elimination of unrelated effects. This experiment shows the effect of these parameters on vibration of drilling machine used in this study. There was a reliable relationship between vibration with texture coefficient and hardness.